RDF45 HydraFlex™ Draper | Grain Harvesting

Equipment
John Deere
#rd45fh

Disclaimer |

Characteristics

  • Harvest crops as close as possible to the ground with the HydraFlex™ cutterbar
  • Minimize grain loss with a two-speed center feed section
  • Enable higher harvesting speed without sacrificing cut quality with a 4” (10.2 cm) double cut, dual drive, shaft driven cutterbar
  • Get more done by eliminating header calibrations

Note that this product is available in store only.
Get pre-approved for financing
SKU: rd45fh Categories: ,

Description

The new RDF45 HydraFlex Draper is available for the S7 800 and S7 900 Combines offering an added five feet of productivity for up to 10% more acres harvested in a day.

Specifications

Cutterbar length 13.72 m
45 ft
Knife drive Double-cut, dual-drive, shaft-driven cutterbar: 10.2 cm
4 in.
Knife speed X Series Combine: 520 cycles/min
S-Series Combine: 490 cycles/min
Pickup reel operating speeds 6-70 rpm
Draper belts speed control Hydraulic from cab (side belts only)
Type Rigid frame flexible cutterbar
Type Straight-line knife drive system
Cutterbar vertical flex: 190 mm
7.5 in.
Length 13.72 m
45 ft
Knife drive Double-cut, dual-drive, shaft-driven cutterbar: 10.2 cm
4 in.
Knife speed X Series Combine: 520 cycles/min
S-Series Combine: 490 cycles/min
Base skid shoe height 3.8 cm
1.5 in.
General Two-piece, poly tine pickup reel with 8-in. (20-cm) tube
Number of slats Six bat poly
Fingers Nylon
Diameter 106.7 cm
42 in.
Height control Hydraulic
Speed control Hydraulic
Reel lift 72 cm
28.3 in.
Reel fore and aft 35.9 cm
14.1 in.
Fore of the cutterbar 40.6 cm
16 in.
Reel resume Base
Reel reverse Base
Operating speeds 6-70 rpm
Width Side belts: 101.6 cm
40 in.
Center belts: 177.6 cm
70 in.
Belt depth 101.2 cm
39.8 in.
Cleat height 19.05 mm
0.75 in.
Operating speed Side belts (variable): 1-3.5 m/s
3.3-11.5 fps
Center belts: 211 m/min
692 fpm
Low-speed center belt (fixed): 4.2 m/s
13.8 fps
High-speed center belt (fixed): 5.1 m/s
16.7 fps
Speed control Hydraulic from cab (side belts only)
Center belt reverse Base
Diameter 414 mm
16.3 in.
Feed drum fingers Heavy-duty and round with breakaway notch and retainer
Diameter: 16 mm
0.625 in.
Number of fingers 21
Auger finger platform Triple chevron, retracting
Finger reach 152 mm
6 in.
Drum/auger reverse Base
Operating speed Low speed: 200 rpm
High speed: 240 rpm
Center cleanout door Base
Type Electrohydraulic
Header height sensing on the ground Base
Header height sensing off the ground Optional: four sensors
Type Optional: hydraulic drive
Size 45.7 cm
18 in.
Platform length 14.6 m
47.9 ft
Overall operating depth With dividers: 2.74 m
9 ft
Transport width, field position 14.6 m
47.9 ft
Approximate weight 4437 kg
9782 lb
Date collected 15 June 2020